https://vulnerability.circl.lu Contains only the most 10 recent entries. http://www.rssboard.org/rss-specification python-feedgen en Wed, 30 Sep 2026 03:40:32 +0000 https://vulnerability.circl.lu/vuln/cve-2026-64125 <p><strong>Affected:</strong> Linux</p> <p>In the Linux kernel, the following vulnerability has been resolved:</p> <p>net: bcmgenet: keep RBUF EEE/PM disabled</p> <p>Setting RBUF_EEE_EN | RBUF_PM_EN in RBUF_ENERGY_CTRL breaks the RX path on GENET hardware once MAC EEE becomes active. RX traffic stops flowing while the link stays up and the usual descriptor/RX error counters remain quiet. In that state the MAC still accepts frames (rbuf_ovflow_cnt keeps climbing) but RBUF no longer forwards them to DMA, so rx_packets is no longer incremented at the netdev level. On some boards the corruption ends up as a paging fault in skb_release_data via bcmgenet_rx_poll on an LPI exit.</p> <p>Reproduced on Pi 4B (BCM2711 + BCM54213PE) and confirmed by Florian Fainelli on an internal Broadcom 4908-family board with the same crash signature. RBUF_PM_EN is not publicly documented.</p> <p>This shows up more often now that phy_support_eee() enables EEE by default, but it also affects older kernels as soon as TX LPI is turned on via ethtool, so it is not specific to recent changes.</p> <p>Always clear RBUF_EEE_EN | RBUF_PM_EN in bcmgenet_eee_enable_set so the bits stay off across resets. UMAC and TBUF setup is left alone so TX-side EEE keeps working.</p> <p><strong>Affected:</strong> Linux</p> <p>In the Linux kernel, the following vulnerability has been resolved:</p> <p>net: bcmgenet: keep RBUF EEE/PM disabled</p> <p>Setting RBUF_EEE_EN | RBUF_PM_EN in RBUF_ENERGY_CTRL breaks the RX path on GENET hardware once MAC EEE becomes active. RX traffic stops flowing while the link stays up and the usual descriptor/RX error counters remain quiet. In that state the MAC still accepts frames (rbuf_ovflow_cnt keeps climbing) but RBUF no longer forwards them to DMA, so rx_packets is no longer incremented at the netdev level. On some boards the corruption ends up as a paging fault in skb_release_data via bcmgenet_rx_poll on an LPI exit.</p> <p>Reproduced on Pi 4B (BCM2711 + BCM54213PE) and confirmed by Florian Fainelli on an internal Broadcom 4908-family board with the same crash signature. RBUF_PM_EN is not publicly documented.</p> <p>This shows up more often now that phy_support_eee() enables EEE by default, but it also affects older kernels as soon as TX LPI is turned on via ethtool, so it is not specific to recent changes.</p> <p>Always clear RBUF_EEE_EN | RBUF_PM_EN in bcmgenet_eee_enable_set so the bits stay off across resets. UMAC and TBUF setup is left alone so TX-side EEE keeps working.</p> https://vulnerability.circl.lu/vuln/cve-2026-64125