Affected: Linux

In the Linux kernel, the following vulnerability has been resolved:

riscv: cpu_ops_sbi: Use static array for boot_data

Since commit 6b9f29b81b15 ("riscv: Enable pcpu page first chunk allocator"), if NUMA is enabled, the page percpu allocator may be used on very sparse configurations, or when requested on boot with percpu_alloc=page.

In that case, percpu data gets put in the vmalloc area. However, sbi_hsm_hart_start() needs the physical address of a sbi_hart_boot_data, and simply assumes that __pa() would work. This causes the just started hart to immediately access an invalid address and hang.

Fortunately, struct sbi_hart_boot_data is not too large, so we can simply allocate an array for boot_data statically, putting it in the kernel image.

This fixes NUMA=y SMP boot on Sophgo SG2042.

To reproduce on QEMU: Set CONFIG_NUMA=y and CONFIG_DEBUG_VIRTUAL=y, then run with:

qemu-system-riscv64 -M virt -smp 2 -nographic \ -kernel arch/riscv/boot/Image \ -append "percpu_alloc=page"

Kernel output:

[ 0.000000] Booting Linux on hartid 0 [ 0.000000] Linux version 6.16.0-rc1 (dram@sakuya) (riscv64-unknown-linux-gnu-gcc (GCC) 14.2.1 20250322, GNU ld (GNU Binutils) 2.44) #11 SMP Tue Jun 24 14:56:22 CST 2025 ... [ 0.000000] percpu: 28 4K pages/cpu s85784 r8192 d20712 ... [ 0.083192] smp: Bringing up secondary CPUs ... [ 0.086722] ------------[ cut here ]------------ [ 0.086849] virt_to_phys used for non-linear address: (____ptrval____) (0xff2000000001d080)…