Affected: Alpaquita:23: linux-lts, Alpaquita:25: linux-lts, Alpaquita:stream: linux-lts

In the Linux kernel, the following vulnerability has been resolved:

IB/isert: reject PDUs declaring more data than was received

isert_recv_done() hands each received PDU to the opcode handlers without ever looking at wc->byte_len, the number of bytes the HCA actually placed in the receive descriptor. The handlers then copy that many bytes - the data-segment length the initiator declared in the BHS (ntoh24(hdr->dlength), via the derived unsol_data_len / imm_data_len) - out of the fixed-size descriptor:

isert_handle_iscsi_dataout(): sg_copy_from_buffer(sg_start, sg_nents, isert_get_data(rx_desc), unsol_data_len); isert_handle_scsi_cmd(): sg_copy_from_buffer(cmd->se_cmd.t_data_sg, sg_nents, isert_get_data(rx_desc), imm_data_len);

Because the declared length is never checked against wc->byte_len, an initiator can declare a data segment larger than the bytes it actually sent (and larger than the descriptor) and cause an out-of-bounds read of the receive buffer.

Nothing upstream of isert closes this door:

- __iscsit_check_dataout_hdr() bounds the inbound payload against conn_ops->MaxXmitDataSegmentLength (MXDSL) - a transmit parameter, used here for the inbound check. - iscsi_set_connection_parameters() sets ops->MaxXmitDataSegmentLength = ops->TargetRecvDataSegmentLength; and TARGETRECVDATASEGMENTLENGTH is absent from the min()-clamp list in iscsi_check_acceptor_state(), so t…

In the Linux kernel, the following vulnerability has been resolved:

IB/isert: reject PDUs declaring more data than was received

isert_recv_done() hands each received PDU to the opcode handlers without ever looking at wc->byte_len, the number of bytes the HCA actually placed in the receive descriptor. The handlers then copy that many bytes - the data-segment length the initiator declared in the BHS (ntoh24(hdr->dlength), via the derived unsol_data_len / imm_data_len) - out of the fixed-size descriptor:

isert_handle_iscsi_dataout(): sg_copy_from_buffer(sg_start, sg_nents, isert_get_data(rx_desc), unsol_data_len); isert_handle_scsi_cmd(): sg_copy_from_buffer(cmd->se_cmd.t_data_sg, sg_nents, isert_get_data(rx_desc), imm_data_len);

Because the declared length is never checked against wc->byte_len, an initiator can declare a data segment larger than the bytes it actually sent (and larger than the descriptor) and cause an out-of-bounds read of the receive buffer.

Nothing upstream of isert closes this door:

- __iscsit_check_dataout_hdr() bounds the inbound payload against conn_ops->MaxXmitDataSegmentLength (MXDSL) - a transmit parameter, used here for the inbound check. - iscsi_set_connection_parameters() sets ops->MaxXmitDataSegmentLength = ops->TargetRecvDataSegmentLength; and TARGETRECVDATASEGMENTLENGTH is absent from the min()-clamp list in iscsi_check_acceptor_state(), so t…

Affected: openEuler:22.03-LTS-SP4: kernel

The Linux Kernel, the operating system core itself. Security Fix(es):

In the Linux kernel, the following vulnerability has been resolved:

netfilter: ipset: fix race between dump and ip_set_list resize

The release path of ip_set_dump_do() and ip_set_dump_done() read inst->ip_set_list via ip_set_ref_netlink(), a plain rcu_dereference_raw() of the array pointer. These run from netlink_recvmsg() without the nfnl mutex and without an RCU read-side critical section.

A concurrent ip_set_create() can grow the array: it publishes the new array, calls synchronize_net() and then kvfree()s the old one. Since the dump paths read the array outside any RCU reader, synchronize_net() does not wait for them and the old array can be freed while they still index into it, causing a use-after-free.

The dumped set itself stays pinned via set->ref_netlink, so only the array load needs protecting. Take rcu_read_lock() around it, matching ip_set_get_byname() and __ip_set_put_byindex().

BUG: KASAN: slab-use-after-free in ip_set_dump_do (net/netfilter/ipset/ip_set_core.c:1697) Read of size 8 at addr ffff88800b5c4018 by task exploit/150 Call Trace: ... kasan_report (mm/kasan/report.c:595) ip_set_dump_do (net/netfilter/ipset/ip_set_core.c:1697) netlink_dump (net/netlink/af_netlink.c:2325) netlink_recvmsg (net/netlink/af_netlink.c:1976) sock_recvmsg (net/socket.c:1159) __sys_recvfrom (net/socket.c:2315) ... Oops: general protection fault, probably for non-can…

kernel-devel-7.2.8-1.1 on GA media

Affected: Ubuntu:Pro:14.04:LTS: linux, Ubuntu:Pro:14.04:LTS: linux-aws, Ubuntu:Pro:14.04:LTS: linux-azure, Ubuntu:Pro:14.04:LTS: linux-lts-xenial, Ubuntu:Pro:16.04:LTS: linux, Ubuntu:Pro:16.04:LTS: linux-aws, Ubuntu:Pro:16.04:LTS: linux-aws-hwe, Ubuntu:Pro:16.04:LTS: linux-azure, Ubuntu:Pro:16.04:LTS: linux-gcp, Ubuntu:Pro:16.04:LTS: linux-hwe and 246 more

In the Linux kernel, the following vulnerability has been resolved: IB/isert: reject PDUs declaring more data than was received isert_recv_done() hands each received PDU to the opcode handlers without ever looking at wc->byte_len, the number of bytes the HCA actually placed in the receive descriptor. The handlers then copy that many bytes - the data-segment length the initiator declared in the BHS (ntoh24(hdr->dlength), via the derived unsol_data_len / imm_data_len) - out of the fixed-size descriptor: isert_handle_iscsi_dataout(): sg_copy_from_buffer(sg_start, sg_nents, isert_get_data(rx_desc), unsol_data_len); isert_handle_scsi_cmd(): sg_copy_from_buffer(cmd->se_cmd.t_data_sg, sg_nents, isert_get_data(rx_desc), imm_data_len); Because the declared length is never checked against wc->byte_len, an initiator can declare a data segment larger than the bytes it actually sent (and larger than the descriptor) and cause an out-of-bounds read of the receive buffer. Nothing upstream of isert closes this door: - __iscsit_check_dataout_hdr() bounds the inbound payload against conn_ops->MaxXmitDataSegmentLength (MXDSL) - a transmit parameter, used here for the inbound check. - iscsi_set_connection_parameters() sets ops->MaxXmitDataSegmentLength = ops->TargetRecvDataSegmentLength; and TARGETRECVDATASEGMENTLENGTH is absent from the min()-clamp list in iscsi_check_acceptor_state(), so the val…